Is a kind of water through the evaporator by the refrigeration system refrigerant cooling to generate ice refrigeration machinery and equipment, the use of refrigeration systems, water carrier, in the state of electricity through a certain device after the manufacture of ice. That the following ice machine manufacturer's editor to introduce you to the specific ice machine how to use? As well as the use of what attention to content, welcome to read!

How to use the specific ice machine?
　　1, before use to check whether the ice machine devices are normal, for example, whether the water supply device is normal, the water tank memory water is normal (there is a water tank has been set at the factory).
　　2、After the work of the ice machine is normal, put the ice machine in a stable position and insert the prepared barrel of water into the water inlet of the ice machine. At this time, seawater will automatically enter the water tank of the ice machine.
　　3、After inserting the power supply of the ice maker, the ice maker will start to work and send the water pump from the water tank to the ice making area. At the beginning, the ice maker will have a process of discharging air, and after the air is discharged the compressor will start and enter the working state, and the ice maker will start to enter the ice making state.
　　4、When the ice thickness in the ice maker reaches the thickness set by the ice maker, the ice plate probe in the ice maker starts to work, the defrost solenoid valve works when the water pump stops working, the hot air enters the evaporator and the ice starts to fall.
　　5、When the ice starts to fall, flip the gear plate and open the magnetic reed switch. When a certain amount of ice is reached, the magnetic spring will close again and the ice maker enters the ice making state again.
　　6、When the ice storage bucket of the ice maker is full, the magnetic reed switch will not close automatically and the ice maker will stop working automatically and the ice making is finished. If you turn off the ice machine power switch and unplug the ice machine, the ice making will be finished.
Ice machine use precautions.
　　1, the ice machine should be installed in a place away from the heat source, avoid direct sunlight, a well-ventilated place, the ambient temperature should not exceed 35 ℃, so as to avoid the ambient temperature is too high and cause poor heat dissipation of the condenser, affecting the ice making effect. The ground of the ice machine should be flat and level, and the ice machine must be kept horizontal, otherwise it will cause no ice removal and running noise.
　　2、The gap between the back and the left and right sides of the ice machine is not less than 30cm, and the gap at the top is not less than 60cm.
　　3、Ice making machine should use independent power supply, special line power supply, and equipped with fuse and leakage protection switch, and should be reliably grounded.
　　4, ice machine water should meet the national drinking water standards, and the installation of water filtration device to filter the impurities in the water, so as not to block the water pipe, pollution pool and ice mold. Have an impact on the ice making performance.
　　5、When cleaning the ice machine should be turned off the power, it is strictly forbidden to use the water pipe to directly flush the body, and use neutral detergent scrubbing, acidic, alkaline or corrosive solvent cleaning is strictly prohibited.
　　6, the ice machine needs two months to spin into the water hose head, clean the water inlet valve screen, to avoid the water mud impurities blocking the water inlet, and cause the water intake becomes small, resulting in no ice.